MK 1 – Kitty Lifter
MK I Molar Flowform built specifically for Hello Kitty using the plans for the FF-04a developed by Harald Prinzler
MK II – Big Yellow
A lower front view of the MK II flowform show the vents in the lower skin
MK II From the Rear
A rear view of the MK II flowform show the vents in the lower skin and the rear vent.
X-2 (MK-VII) Profiles
3D rendering of the internal profiles for the X-2 (MK-VII)
X-2 (MK-VII) – Leading Edge Profiles
3D rendering fo the X-2 (MK-VII) profiles including the profiles for the inflatable leading edge.
X-2 (MK-VII) – Upper Skin
3D Rendering of the X-2 (MK-VII) showing the upper skin and the wrap around with the fill vents on the upper inflatable leading edge
X-2 (MK-VII) – Lower Skin
3D rendering of the MK-VI showing the lower skin.
X-2 (MK-VII) – Lower View
3D rendering show the X-2 (MK-VII) from below
X-2 (MK-VII) – Upper View
3D renders showing the X-2 (MK-VII) from above
You must be logged in to post a comment.